MYZR-I.MX8Mmini-CB240 Programming Manual

来自明远智睿的wiki
Admin讨论 | 贡献2020年10月26日 (一) 08:52的版本 (创建页面,内容为“### download file ------    Open the network disk to "2.1_OS_Linux-4.14.98 -> 01_ManufacturingToolkit", download the "UUU-MYIMX8MM-L4.14.98" directory and the...”)

(差异) ←上一版本 | 最后版本 (差异) | 下一版本→ (差异)
跳转至: 导航搜索

download file


   Open the network disk to "2.1_OS_Linux-4.14.98 -> 01_ManufacturingToolkit", download the "UUU-MYIMX8MM-L4.14.98" directory and the "UUU-MYIMX8MM-L4.14.98-Patch.*.rar" compressed package.

unzip files


Unzip MYIMX8MM-L4.14.98-Patch.*.rar, copy fsl-image-validation-myimx8m.tar.bz2 and fsl-image-validation-myimx8m.manifest to image-rootfs-L4.14.98 directory.

Connect the programming line


   Power off the development board and connect the programming port of the development board to the PC with a USB cable.

Dial code to download mode


   and set the "Boot Mode" of the development board to "OFF ON".

Perform burning


   Power on the development board, double-click to run the "myimx8mmek240-8mm.bat" file, then the Windows command line window will see the following information:

<code>uuu (Universal Update Utility) for nxp imx chips - libuuu_1.2.135-0-gacaf035
Success 0 Failure 0
1:32 ......
</code>

Burning complete


   After the burning is completed, the Windows command line window information is as follows:

<code>uuu (Universal Update Utility) for nxp imx chips - libuuu_1.2.135-0-gacaf035
Success 1 Failure 0
1:32 24/24 [Done] FBK: DONE
Please press any key to continue...
</code>

Start the development board


   Power off the development board, switch "Boot Mode" to "ON OFF", and power on the development board, the development board can start normally